Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 3 de 3
Filtrar
Mais filtros










Base de dados
Intervalo de ano de publicação
1.
Clin Biomech (Bristol, Avon) ; 69: 79-86, 2019 10.
Artigo em Inglês | MEDLINE | ID: mdl-31302493

RESUMO

BACKGROUND: The forces acting on the human clavicle in vivo are difficult if not impossible to measure. The goal of this study is to quantify the forces acting on the human clavicle during shoulder abduction, forward humeral elevation and three activities of daily living using the Delft Shoulder and Elbow Model. METHODS: The Delft Shoulder and Elbow Model and a computed tomography scan of a clavicle were used to calculate the forces and moments acting on the entire clavicle and on three planes within the middle third of the clavicle during the simulated movements. FINDINGS: The largest resultant force simulated across the clavicle was 126 N during abduction. Maximum resultant moments of 2.4 Nm were identified during both abduction and forward humeral elevation. The highest forces in the middle third of the clavicle were of a compressive nature along the longitudinal axis of the clavicle, increasing to 97 N during forward humeral elevation and 91 N during abduction. Forces in opposite direction along the y-axis were identified on either side of the conoid ligament. The three simulated activities of daily living had similar ranges of forces and moments irrespective of the sagittal plane in which these activities were performed. INTERPRETATION: Peak forces occurred at different locations on the middle third of the clavicle during different movements. The results create an understanding of the forces and their distribution across the clavicle during activities of daily living. These data may be helpful in the development of clavicular fixation devices. LEVEL OF EVIDENCE: Biomechanical study.


Assuntos
Atividades Cotidianas , Clavícula/fisiologia , Ligamentos Articulares/fisiologia , Amplitude de Movimento Articular , Articulação do Ombro/fisiologia , Fenômenos Biomecânicos , Humanos , Úmero , Imageamento Tridimensional , Ligamentos/fisiologia , Masculino , Pessoa de Meia-Idade , Movimento , Ombro , Estresse Mecânico , Tomografia Computadorizada por Raios X
2.
J Appl Physiol (1985) ; 126(5): 1445-1453, 2019 05 01.
Artigo em Inglês | MEDLINE | ID: mdl-30571291

RESUMO

This review, the first in a series of minireviews on the passive mechanical properties of skeletal muscles, seeks to summarize what is known about the muscle deformations that allow relaxed muscles to lengthen and shorten. Most obviously, when a muscle lengthens, muscle fascicles elongate, but this is not the only mechanism by which muscles change their length. In pennate muscles, elongation of muscle fascicles is accompanied by changes in pennation and changes in fascicle curvature, both of which may contribute to changes in muscle length. The contributions of these mechanisms to change in muscle length are usually small under passive conditions. In very pennate muscles with long aponeuroses, fascicle shear could contribute substantially to changes in muscle length. Tendons experience moderate axial strains even under passive loads, and, because tendons are often much longer than muscle fibers, even moderate tendon strains may contribute substantially to changes in muscle length. Data obtained with new imaging techniques suggest that muscle fascicle and aponeurosis strains are highly nonuniform, but this is yet to be confirmed. The development, validation, and interpretation of continuum muscle models informed by rigorous measurements of muscle architecture and material properties should provide further insights into the mechanisms that allow relaxed muscles to lengthen and shorten.


Assuntos
Contração Muscular/fisiologia , Músculo Esquelético/fisiologia , Aponeurose/fisiologia , Humanos , Tendões/fisiologia
3.
Hum Mov Sci ; 31(2): 429-47, 2012 Apr.
Artigo em Inglês | MEDLINE | ID: mdl-22244106

RESUMO

This paper aims to develop an EMG-driven model of the shoulder that can consider possible muscle co-contractions. A musculoskeletal shoulder model (the original model) is modified such that measured EMGs can be used as model-inputs (the EMG-driven model). The model is validated by using the in-vivo measured glenohumeral-joint reaction forces (GH-JRFs). Three patients carrying instrumented hemi-arthroplasty were asked to perform arm abduction and forward-flexion up to maximum possible elevation, during which motion data, EMG, and in-vivo GH-JRF were measured. The measured EMGs were normalized and together with analyzed motions served as model inputs to estimate the GH-JRF. All possible combinations of input EMGs ranging from a single signal to all EMG signals together were tested. The 'best solution' was defined as the combination of EMGs which yielded the closest match between the model and the experiments. Two types of inconsistencies between the original model and the measurements were observed including a general GH-JRF underestimation and a GH-JRF drop above 90° elevation. Both inconsistencies appeared to be related to co-contraction since inclusion of EMGs could significantly (p<.05) improve the predicted GH-JRF (up to 45%). The developed model has shown the potential to successfully take the existent muscle co-contractions of patients into account.


Assuntos
Eletromiografia/instrumentação , Prótese Articular , Modelos Anatômicos , Músculo Esquelético/fisiopatologia , Redes Neurais de Computação , Articulação do Ombro/fisiopatologia , Articulação do Ombro/cirurgia , Ombro/fisiopatologia , Processamento de Sinais Assistido por Computador , Idoso , Feminino , Humanos , Contração Isométrica/fisiologia , Masculino , Atividade Motora/fisiologia , Osteoartrite/fisiopatologia , Osteoartrite/cirurgia , Complicações Pós-Operatórias/fisiopatologia , Amplitude de Movimento Articular/fisiologia , Valores de Referência , Suporte de Carga/fisiologia
SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA
...